Greetings S-users/-abusers (a .edu and yet still courteous! *tongue in cheek*)
I have a surface generated using persp(). The z axis has a range -50 to 10
and I want to increase the visibility of the surface at the 0 value for z.
I would like to do this by putting a plane through the z-axis at the 0
value. Is this possible?
Any other thoughts/methods for increasing visibility on a persp() appreciated.
Cheers -Jon
=================================================================
Mr Jonathan Monteleone (MS)
Department of Pharmacology & Clinical Pharmacology
School of Medicine and Health Sciences
University of Auckland
Auckland, New Zealand
Phone: +64.9.373.7599 ext. 6732 Fax: +64.9.373.7556
Home: +64.9.529.1477
Email: monte@ihug.co.nz
-----------------------------------------------------------------------
This message was distributed by s-news@wubios.wustl.edu. To unsubscribe
send e-mail to s-news-request@wubios.wustl.edu with the BODY of the
message: unsubscribe s-news
|