Dear All,
I am currently trying to run my simulations in batch
mode on UNIX using S+ 5.1, however I am not quite sure how to use the
options(echo=F) command in my Splus BATCH in out
command syntax? Is it also possible to change or create an object in the Splus directory rather than creating an output? My output
is a complex list and it can be daunting to try to convert the list back into Splus form to do some analysis!
Just another general question to the S simulation
people at large, does the use of if command slows down the process? I have
avoided any do and for loop so far, but given the complexity of the program, it
still tends to run quite slowly. I am seeking ways in which I can make it run
faster, so any general comments relating to this area would be useful J
Thanks for your attention.
**************************************************************************************
Steve Su (s.su@qut.edu.au)
PhD student.
School of Accountancy
School of Mathematical Sciences
Queensland University of Technology
Postal Address: Steve Su, School of Accountancy, QUT, PO Box 2434, Brisbane,
Queensland, Australia, 4000.
Phone: +61 7 3864 2017
Fax: +61 7 3864 1812
Mobile: 0421 840
586
.
_--_|\
/
QUT
\_.--._/
v
**************************************************************************************